Not yet rated
Loading ...Not More Perspex
bentleya
24th February 2008
After drilling most of the holes yesterday for the front plexi I am now moving on to the fan box which is going to be made out of 6mm clear Perspex, I haven’t finished the front plexi, due to the fact I a m waiting for my 114mm hole saw to be delivered
I checked over the measument for the fan box, in which got cut out, and I forgot when I designed it that it wound be 10mm, so I have drawn out the new lines to be cut
As you can see in the picture below where the blade got hot when I was cutting it with my jigsaw, it has melted it a bit leaving the sides stringy a bit of sanding should solve the problem
I will not start to drill the holes in the box to my hole saw comes, so I am just going to sand down the edges to make the fit better
As I have got to sand the edges down I fort I wound give it a little test fit just in case I sand to much off
I told you a few updates ago that I was changing the side panel, I have cut out the centre of the side panel ready for Perspex
I have marked out the Perspex that will go on the side panel ready to be cut
All clamped up ready to be cut
All cut, time to mark the new design
A little test fit, WOW perfect first time, me happy
New design marked out, and ready to me cut
A little test fit, just gotta cut out a bit more on the real side panel
Sorted now for the cutting of the Perspex
A couple of holes for the jigsaw
Centre Cut Out
All Cut Out
Another Test Fit
ok on to the sides of the side panel, I will cut this pipe into 4 to make the corner sections of the panel
and here it is chopped up
that’s it for now happy modding, and there might be an update later, I’ve had to stop cos it’s started to rain and my work area is outside
This article has no comments yet.